2015 Jeep Patriot Serpentine Belt Diagram (2024)

FAQs

How do you find a serpentine belt routing diagram? ›

Vehicle manufacturers produce serpentine belt diagrams that are designed to aid with this task. Some vehicles have the serpentine belt diagram located on a decal somewhere in the engine compartment.

Common problems found on the 2015 Jeep Patriot include water leaking into the cabin, the engine stalling while driving, and problems with the computer.

Jeep Serpentine Belt Replacement Cost Estimates

The average cost for a Serpentine Belt Replacement is between $106 and $118 but can vary from car to car.

A: Commonly a belt routing diagram sticker is on the underside of the hood or in the engine compartment. If there is no diagram, make a sketch of the belt and pulleys before removing the belt.

As an example, “8PK2515” is the PK number found on an OEM serpentine belt. The first digit indicates an eight-rib belt, followed by “P” to identify metric belt sizing, and a “K” showing that this belt conforms to the SAE standard for rib sizing (3.56 millimeters wide for automotive-type serpentine belts).

There are two ways to align pulleys: Traditional and laser. Traditional alignment methods are quick but often inaccurate. With these methods, mechanical tools such as straightedges, tape measures, wire, string, feeler gauges, spirit levels and calibrated cones are used.

AUBURN HILLS, Michigan — Fiat-Chrysler is recalling an estimated 60,107 2015 Jeep Compass and Jeep Patriot SUVs in the U.S. because of a fire risk linked to a low-pressure return hose, the company said late last week.

According to vehiclehistory.com, you can expect the Jeep Patriot to last around 200,000 miles with proper care. If you're someone who ensures your vehicle is in pristine shape, it could last far beyond that point.

Plus, replacement is relatively easy, and if you're wondering how long does serpentine belt service take, it's less than an hour for most vehicles.

You can replace only the pulley, or you can buy a new tensioner with a new pulley attached, or you can buy a kit with a new belt, tensioner/pulley, and idler pulley if there is one, and do it all.

Can I replace serpentine belt myself? ›

Replacing the serpentine belt is as simple as threading it into position, cranking the tensioner and slipping the belt over the tensioner pulley, or nearest pulley up top. Belt tensioners are mostly spring tension. Once installed, the spring retains pressure to the belt.

A timing belt has horizontal “teeth” designed to fit the cogwheels of the crankshaft and camshaft. A serpentine belt has V-shaped grooves that run vertically along the belt.

Check if the belt runs centrally on the pulleys. Any sideward movement or slippage can indicate misalignment. Straightedge or String Line: Place a straightedge or taut string along the faces of the pulleys to see if they line up perfectly. Any deviation from a straight line suggests angular or parallel misalignment.

If the belt is already out of place, locate the driver's manual or the under-the-hood placard, where you'll find a sketch of the routing.

The tensioner pulley is responsible for keeping the belt tense while making sure it stays aligned the entire time you're driving. While the location of the tensioner pulley can vary depending on the vehicle, you can usually find it at the end of the tensioner, which is typically connected to the accessory drive belt.

What Is the Ribbed Belt Profile and Number of Ribs? Ribbed belts have lengthwise grooves on the inside. Measure the pitch of the groove, i.e. distance between projections, e.g. 3.54 mm = belt type PK. Count the number of grooves, i.e. the number of projections - e.g. 7, as shown in the picture.